ریزنشت کرونالی حاصل از کاربرد مواد همرنگ مختلف همراه با پست‌های تقویت شده با فیبر در استحکام‌بخشی دندان‌های ضعیف: یک مقایسه آزمایشگاهی

نوع مقاله : Original Articles

چکیده

مقدمه: علاوه بر استحکام‌بخشی مواد چسبنده به عاج، ریزنشت آنها به عنوان یک شاخص در بازسازی دندان مورد توجه قرار گرفته است. هدف از این مطالعه، بررسی میزان ریزنشت کرونالی هنگام استفاده از مواد همرنگ مختلف در ناحیه ریشه به همراه پست‌های شفاف در تقویت دندان‌های قدامیِ درمان ریشه شده، بود.
مواد و روش‌ها: در این مطالعه مداخله‌ای- تجربی، 48 دندان سنترال فک بالای کشیده شده سالم جمع‌آوری و به چهار گروه 12 تایی تقسیم شد. درمان ریشه در مورد همه نمونه‌ها صورت گرفت و سپس از 2 میلی‌متری بالای محل اتصال سمان به عاج، تاج از ریشه جدا شد. با گشاد کردن کانال ریشه، استوانه‌ای یکنواخت برای مشابه‌سازی آنها به دندان‌های ضعیف شده ایجاد گردید. در گروه اول، کانال گشاد شده صرفاً با گوتاپرکا پر شد. در مورد بقیه گروه‌ها پس از آماده‌سازی دیواره کانال ریشه، سطح پست بعد از تمیز کردن با الکل، به ماده باندینگ آغشته و کیور شد. در گروه دوم، پست توسط کامپوزیت تراکم‌پذیر، ودر گروه سوم توسط کامپوزیت سلف کیور گردید و در گروه چهارم، با کامپوزیت دوال کیور همزمان با تقویت دیواره ضعیف شده ریشه چسبانده شد. بعد از آماده‌سازی، دندان‌ها از وسط پست دو نیمه شدند. بررسی ریزنشت با استریو میکروسکوپ مجهز به دوربین دیجیتالی در مقیاس میلی‌متر انجام گرفت. برای مقایسه میانگین ریزنشت بین گروه‌های مورد مطالعه، از آزمون آنالیز واریانس یک طرفه و برای مقایسه میانگین ریزنشت بین هر دو گروه از پس‌آزمون (Least Significant Difference-LSD) استفاده شد.
نتایج: بیشترین میزان ریزنشت بر حسب میلی‌متر مربوط به گروه کنترل و کمترین آنها مربوط به گروه سوم بود. اختلاف میانگین ریزنشت بین گروه‌های مورد مطالعه معنی‌دار بود.
نتیجه‌گیری: استفاده از مواد همرنگ به عنوان عامل تقویت‌کننده در مقایسه با عدم استفاده از این مواد، منجر به کاهش ریزنشت می‌گردد. میزان ریزنشت حد فاصل ریشه و ماده چسبنده در مقایسه با حد فاصل ماده همرنگ و پست بیشتر است.

عنوان مقاله [English]

An Invitro Evaluation of Coronal Microleakage in Strengthening of Weakend Teeth with Different Tooth-Coloured Material with

چکیده [English]

Introduction: The purpose of this in vitro study was to investigate coronal microlenkage in anterior weakend teeth after root canal therapy, reinforced with different tooth-coloured material and FRC post.
Methods and Materials: A total 48 extracted intact central incisor were randomly divided into four experimental groups (n=12). All specimens were endodontically treated using lateral condensation and crowns were totally removed from 2mm of CEJ and were over flared to simulate weakened teeth . Control group (group I) was restored only with gutta percha .In other groups root canal walls were prepared (etching, washing and gentle drying, bonding) and the surface of the posts were cleaned with alcohol and after that covered with bonding agent and then light polymerized for 40 seconds. Finally post cementation was done durig reinforcing of weakened root canal walls with packable composite in group II, self-cure composite in group III and dual cure composite in group IV. All specimens were thermocycled for 500 cycles between 5ºc and 55ºc0 with a dowel time of 20 seconds before immersion in dye. Then all specimens were sealed with sticky wax and coated with two layer of nail polish & then they were placed in 0.5% fuchsine for 24 hours at room temperature and were sectioned longitudinally from the center of post with tooth cutter. Dye penetration in both sections of each tooth were evaluated using a stereomicroscope equipped with digital camera at original magnification of 32× and microleakage recorded in m. One-way analysis of variances (ANOVA) and least square difference were used for statistical analysis.
Result: The control group showed the maximum microleakage and the minimum was related to the third group .There was a significant difference among the average microleakage of all groups.
Conclusion: Combination of FRC post and tooth-coloured materials did reinforce structurally compromised root and decreased microleakage and also the microleakage of root/bonding material is more than post/tooth-colored material. Microleakge in selfcure Group because of its polymerization was the least.